Hi @CompositeCamel5,
If you add centre points, it can change the minimum number of runs in the case where you don't have any spare runs to estimate the terms in your model. Centre points can estimate curvature effect but not allocate this curvature effect precisely to one specific quadratic effect (it can be allocated to any of the quadratic effect).
In the last example with the design with 5 blocks of 3 runs, you can add up to 2 centre points without changing the number of runs : as you need to estimate 14 terms, you can add 1 centre point (to get to 15 total minimum runs), and you can add one centre point that will estimate one of the quadratic effect in replacement of one design point in the matrix (the other quadratic effects will be estimated with specific points). But since you can't allocate specifically centre points to specific quadratic effects, if you increase the number of centre points to 3, then the number of runs increase to 16 : As you need to estimate 14 terms, one of these run can be a centre point for one of the quadratic effect and you need 2 more runs for the 2 extra centre points specified. A small imbalance is accepted here.
Hope this further helps you in your understanding,
Ok @CompositeCamel5, I'll try my best.
If we take the first example, 3 continuous factor and a RSM model design, and make the number of runs/block and centre points vary :
Hope the follow-up explanation clarify the minimum runs calculation,
Welcome in the Community !
When you enter a block factor in your Custom design, this block factor is considered as a fixed effect, so your model will have a new main effect to estimate. Since there are no interactions between the fixed block effects and other factors, or any higher order effect for the block effect, the number of runs will change based on the number of runs for each block in your design.
Hope this answer will help you,
I really appreciate your answer and would like to ask one more question: On this basis, if the number of center points is incorporated, how is the minimum number of experiments calculated? That is to say, in a customized design, if block factors are included among the factors, Response Surface Methodology (RSM) is integrated into the model, and the number of center points is added, how should the minimum number of experiments be calculated?
Thank you very much for your explanation — it was really helpful to me! To deepen my understanding, could you please provide two further examples? For instance, when a blocking factor is included and RSM terms are added to the model, how would the minimum number of runs be calculated when the number of runs per block is 5, and when it is 6, with different numbers of center points added?