Modification of values of factor in DOEI have run a DOE in which one factor is continuous and it has quadratic effect in the model. The range in -0.15 to +0.15, so JMP creates the DOE with -0.15, 0.00 and +0.15.
The problem is that it may be difficult during the experiment to have exactly these number. Therefore, I was wondering whether it is possible to modify in the DOE table after the experiment is performed.
Is this going to affect the results from the model?
I have attached the original DOE table looks like, and the modified DOE table showing how it could look like after the experiment.
Design of ExperimentsRe: Modification of values of factor in DOEHi @bbenny7,
Yes, it is always possible to edit values after having generated the design, the analysis will take ito consideration the edited values :
Altering factor values once you have already made the design and the table (CUSTOM DESIGN)
How DoE model evaluation impact final model after experiment?
Can I add a factor to an existting DOE and/or change the values of any run in an existting DOE?
Little changes in factors' values (like 0,145 instead of 0,15) won't change a lot the performances of the design and results of the analysis, but I'm more concerned about the row 3, where there is a sign difference between the original and modified designs. Is it a typo, an experimental issue, ... ?
The sign change creates a big lack of optimality, significant reduction in chances of detecting the effects in the model (power analysis) and increase the prediction variance over the experimental space and correlations between factors :
If the sign change at row 3 is only a mistake/typo (and is kept negative like in original design), the designs are very similar :
You can compare the designs by using the platform Compare Designs (jmp.com)
Hope this will help you,
Re: Modification of values of factor in DOEHi @Victor_G , thank you for you explanation.
In Row 3 there was a typo, so I should be fine with adjusting the values.
