We designed a Definitive Screening Design with five factors and three blocks and three centre points.
The range of one factor is assymmetric (With the test we would not produce any results at low concentrations of E (e.g. 25)). Therefore we set the range (35-75) with the lowest possible concentration of E (35) and adjusted the centre point of E after DOE design accordingly (55->50).
After DOE evaluation c-E was not significant for any of the results.
Is this outcome based on the results determined or is it caused by the manipulation of the DOE design?
You can find the file attached. Two sets of results have been produced in sequence: Order: block 1 with t-P=8 and 20 min, block 2 with t-P=8 and 20 min and block 3 with t-P=8 and 20 min,