Hello experts,
I'm having problem to build a Run-chart for attribute (defect %) which will trigger a warning after 3 consecutive points above target defect %.
For example below are the images from Control chart builder.
I use P-chart to monitor every group defect %.
Based on JMP calculation, only Test 1 (Test beyond limit) trigger due to 1 point exceed Zone A
The calculated limit / zones A,B,C are very high against our target defect % of 5%.
Is there any way to customize the zone limit/test so that if i got 3 consecutive points >5% , it will give a warning?
Thank you
