437199_en-US

liliconcom

JMP 16 Get Script

I am used to getting a data table all setup for how I want columns and formulas in my data table, then running a get script to get all the columns and formulas I added.

E.g., 

dt = current data table();
dt << Get Script;

 

After the script is run I copy from the log the new columns I added, pasting into a new script and when I pull new raw data, I can then just run the script to add the columns and formulas.

When I run the above script, the log (enhanced in JMP16) just shows it ran and shows three dots ...  

Am I missing something?  I can not find the "log" of column info

Data TableScriptingRe: JMP 16 Get Script

This message might offer a better way to accomplish what you want to do.

 

Re: JMP 16 Get Script

 Okay it works, but had to figure out how it works.  Did not see anything in the log, but if I open a script window and just paste (from clipboard) all the data is in the clipboard.  It was not clear that the data I want is in the clipboard now (use to be in the log).

 

 

dt = current data table();
dt << Copy Table Script("No data");
//After running this, the table information is in the clipboard (not the log).