How to clean up my Spec Limit Table

rmthomas

Hello Everyone,

 

I am pulling my spec limits from a data table that is  and they have a few issues I have noticed with my data:

Case 1. the LSL and the Target are the same number 

Case 2. The Target and the USL are the same number 

Case 3: If LSL and Target are Zero (0) 

 

is there a JSL solution to get rid of these issues?

 

What I want:

Case 1: Remove the Target  if LSL is the same

Case 2: Remove the Target if the USL is the same 

Case 3: Remove the LSL  if Target is Zero (0)

 

This is an example of what I have.

 

 

This is what I would like to have

 

 

 

I have not had any luck trying to get this to work with the JMP Scripting Index. 

 

Any help would be much appreciated.

 

Thanks, 

 

-Ryan 

jthi

This is fairly simple to script. Below is an example script which should handle the case1 (take note that order does matter with these):

Names Default To Here(1);

dt = New Table("Specs",
	Add Rows(5),
	New Column("Column 1",
		Character,
		"Nominal",
		Set Values({"Part 1", "Part 2", "Part 3", "Part 4", "Part 5"})
	),
	New Column("LSL", Numeric, "Continuous", Format("Best", 12), Set Values([0, 38, 93, 9, 9])),
	New Column("TARGET", Numeric, "Continuous", Format("Best", 12), Set Values([0, 40, 94, 10, 9])),
	New Column("USL",
		Numeric,
		"Continuous",
		Format("Best", 12),
		Set Values([13, 41, 94, 10, 10])
	)
);

//ORDER MATTERS WITH THESE (see case1 vs case3)
//case 1<BR />wait(2); //to help with visualization on what is going on
curRows = dt << Get Rows Where(:LSL == :Target);
:Target[curRows] = .;
//case 2

//case 3

You can use << Get Rows Where(condition) to get the rows you want to modify in a matrix and then use that matrix with data table subscripting to update values.