Identify Onset Point in ProcessI am trying to identify the temperature in my process when densification of the part begins. I labeled this on the graph below with an orange line. I also want to identify the temperature when densification pauses, as labeled by the green line. Can someone help me to figure out a script to do this?
Data TableScriptingRe: Identify Onset Point in ProcessWhat are the rules or algorithm to use to detect this....or are you asking the Community to determine such rules?Re: Identify Onset Point in ProcessI am open to suggestions. Basically the onset of densification is the point when the ram travel changes a lot over just a few data points. Densification pauses when there isn't a change in the ram travel for a set number of points (I am not sure of a specific number.) I figured that I could modify the formulas suggested to deal with the final specifics. Does this help?
Re: Identify Onset Point in ProcessHow about something like, the Onset Point has been reached if the mean of the next X number of points - the standard deviation of those X number of points is less than the current data value?Re: Identify Onset Point in ProcessThat definition sounds like a good start. How do I then pull the temperature value that corresponds to the Onset Point on the Ram Travel?
