Hello everyone,
I have the problem that I like to use the control chart builder and the Lot numbers I put in the x-axis do not stay as set, when I save it as script to use again, once my data table is refreshed. I got four control charts save in the script and usually the first one has the set right, but the other three don't. So every time I start the script I have to set the last three control chart again. A bit of a hassle it is.
"Charge",
{Min( 113 ), Max( 147.5 ), Inc( 1 ), Minor Ticks( 0 )}
),>
That's the code for the first box, but for the others it is the same:
"Charge",
{Min( 113 ), Max( 147.5 ), Inc( 1 ), Minor Ticks( 0 )}
),>
and so on.
So where is my error? I just set all the control charts and the saved it as a script. So I guessed JMP will provide all the right details for it.
Hope someone can help me out!
See you
Jan
My guess is that you are using an older version of JMP. I ran similar code in 14.2 and saw the problem you were seeing. I ran the same code in 15.2.1 and it worked as expected. There was a bug that was fixed at some point.
If you could reproduce this with some example data and code that would greatly help.
Here is the code that I used that worked in 15.2. Does this work for you?
dt=Open("$SAMPLE_DATA/Big Class.jmp");
obj=dt<<CONTROL chart="" builder=""></CONTROL>JMP is pretty good, but on rare occasions the saved script can be incomplete.Cases that are confirmed as such should be reported via support@jmp.com. If you are able to post your script here, I'm sure someone would take a look. Change the column names used if they are sensitive.
