Getting Table into a Tablebox?

Question

I figured this would be very elementary, but I cannot seem to figure this one out.  I would like to put a table's data and column names into a TableBox() in a NewWindow() I created [not a journal].   The TableBox() info in the Scripting Guide isn't helping.

Note: Table has mixed data, so cannot Get As Matrix first.

dt = current data table();
New Window("bob",
	TableBox()
);

Ideas?

unknown · Answer

Okay, implemented.  Worked like a charm.  Thanks again.

pmroz · Answer

I haven't found an easier way to do it.  If you have a lot of columns you could generate the code in a loop and then eval(parse()) it.

No clue about the space between the borders.  It's a JMP feature I guess.

unknown · Answer

That's a little more code than I was hoping for.  I wish there was a "getaslist" function to snag a table with non-numeric data.  However, it does the job very nicely.  I'm going to paste that in! Thanks a billion!

Any clue why the borders are separated between Age and Sex in the output?

can't type
Message was edited by: The Chadd