JMP Subscription - AEM Validation TestUsers that purchase a JMP Subscription have the ability to check their subscription status. This can be done via the product or by clicking a link on the JMP Subscription landing page. Users will then get taken to the JMP Subscription Welcome page (currently US only):
PROD - https://www.jmp.com/en_us/subscription/welcome.html https://www.sas.com/jmp/en_us/subscription.html
STAGE - https://wwwstage.jmp.com/en_us/subscription/welcome.html https://wwwstage.sas.com/jmp/en_us/subscription.html
TEST - https://aem6testweb.jmp.com/en_us/subscription/welcome.html
A Data Table component is being used to access a database of subscription info. We’ve created some test subscriptions which have been tied to a gmail address (see below). The following validation test should be run during AEM deployments and dry runs to make sure the Data Table is functioning as intended.
Test steps:
- Open Welcome page (see links above)
- Log into SAS Profile using the following gmail address (same email should work in all three environments):
- email: jmp.web.tester@gmail.com
- password: "4Test!ng"
- The Data Table should then populate with three subscriptions.
- Note: The activation codes should contain “PROD”, “STAGE” or “TEST” depending on the correlating AEM environment that is being tested.
- Note: At author (in each environment) the Data Table should display a single record with "subscription email" listed as first.last@jmp.com.
AEMTraining Materials
