JSL - Using array value for creating Bivariate

adjo9835

 

Hello.  I am trying to pass the first value of an array into the Where() function, inside of the Bivariate() funtion, as shown below.  No matter how I pass the first element of the array (character) into the funtion, I recieve this error message:

This Where-clause for data table 'sample_CV_data 4' resulted in no rows: :c_type == "Cdg" & :process == processArray[1]

 

//Begin
DataCV=open("C:\Desktop\JMP\sample_data.csv");  
ProcessArray = {G20-3};
biv = Bivariate(
	Y( :c_mm_deembed_pf ),
	X( :v_dut_volt ),	
	Where( :c_type == "Cdg" & :process == processArray[1] ),
	Fit Spline( 0.1, standardized, {save predicteds})
);
//End

Some alternate versions that i have tried are shown below.  All result in the same error message, shown above.

DataCV=open("C:\Desktop\JMP\sample_data.csv");  
ProcessArray = {G20-3};
biv = Bivariate(
	Y( :c_mm_deembed_pf ),
	X( :v_dut_volt ),	
	Where( :c_type == "Cdg" & :process == Char(ProcessArray[1]) ),
	Fit Spline( 0.1, standardized, {save predicteds})
);

DataCV=open("C:\Desktop\JMP\sample_data.csv");  
ProcessArray = {G20-3};
var1 = char(processArray[1]);
biv = Bivariate(
	Y( :c_mm_deembed_pf ),
	X( :v_dut_volt ),	
	Where( :c_type == "Cdg" & :process == var1 ),
	Fit Spline( 0.1, standardized, {save predicteds})
);

DataCV=open("C:\Desktop\JMP\sample_data.csv");  
ProcessArray = {G20-3};
var1 = processArray[1];
biv = Bivariate(
	Y( :c_mm_deembed_pf ),
	X( :v_dut_volt ),	
	Where( :c_type == "Cdg" & :process == var1 ),
	Fit Spline( 0.1, standardized, {save predicteds})
);

DataCV=open("C:\Desktop\JMP\sample_data.csv");  
ProcessArray = {G20-3};
var1 = processArray[1];
biv = Bivariate(
	Y( :c_mm_deembed_pf ),
	X( :v_dut_volt ),	
	Where( :c_type == "Cdg" & :process == char(var1)),
	Fit Spline( 0.1, standardized, {save predicteds})
);

 

 

 

adjo9835

Figured it out! I didnt have G20-3 in quotes.  Should have had ProcessArray = {"G20-3"}, instead of ProcessArray = {G20-3}

 

How does one delete a thread that they started?