2716_en-US

liliconcom

select isn't selecting the right itemsHi,

I have number of iterations of the below....where each one uses a different X & Y column. In 2 of these iterations the results are totally wrong and JMP selects a subset that is obviously wrong (lots of X < 40 and lots of Y that equal 1)

Any ideas?


//select X to get a list of items for this phase that need escalation
dt < dt < 40 & :Y==0 );
dt
edit to make code example show up

Message was edited by: alex

Message was edited by: alex

Message was edited by: alex

Message was edited by: alex

Message was edited by: alexRe: select isn't selecting the right itemsMaybe the row selection is not always able to match the iteration rate, i.e. the subset is created before the row selection is finished.

Try to insert a Wait(0.5) command in each iteration (experiment with different arguments, sometimes Wait(0) is sufficient).

Message was edited by: MSRe: select isn't selecting the right itemsIt turns out that the above happens where NONE of the lines in the set match the criteria.

So, instead of getting the subset of everything that matches X & Y, because nothing matches X & Y, JMP actually grabs a much bigger subset...(but not the whole set)

Seems very odd.

Any further suggestions?